Assembly Instructions
‍

Sensors

Remove the sensors from their packaging.
Use the included Torx wrench to remove the white cover from the sensor to expose the sync ports.
Place the sensors on the included ball heads & stands, or other mounts.
‍

Cables — Data + Power Harnesses

Plug the power cable’s DC barrel connector into the sensor, and plug the USB Type-A connector into the included power supply.
Plug the sensor’s power supply into the AC connector on the SENSOR side of an included USB+Power extender.
Plug the sensor’s USB Type-C plug into the sensor, and the USB Type-A plug into the USB Type-A (f) connector on the included USB+Power extender. Plug the PC end of the extender cable into a suitable USB port of your capture computer.
‍

Cables — Sync

Remove the 3.5mm sync cables from the packaging.
Connect the cables from one sensor's Sync Out to the next sensor's Sync In. Press firmly to ensure the cables are fully seated. The first sensor in the chain will have nothing plugged into its Sync In port, and the last sensor will have nothing plugged into its Sync Out port.
‍

Cables — Everything Else

Remove the calibration chart from the packaging and mount it to a stand using the included clamp and ball head.
Make sure your capture volume has plenty of sensor-friendly light.

Follow our documentation to finalize your equipment setup, calibrate, and record.